Skip to content
S9921Senate2023-2024 Session

Allow Sealed Insulated Attics

Official title

“Permits unvented attics and unvented enclosed rafter assemblies to be sealed with air-impermeable insulation in order to help attain building decarbonization goals”

Sponsor James SkoufisSD-42
Status
In Senate Committee
Rules
Impact
7/10
Significant
Passage
0%

Bill progress

Step 2 of 7

In committee · Rules

What's happening

This bill allows unvented attics and rafter assemblies to use air-impermeable insulation to support New York's building decarbonization goals.

Why it matters

  1. Encourages improved building energy performance. By allowing unvented attics and rafter assemblies to use air-impermeable insulation (like spray foam), buildings can achieve tighter seals, reducing energy loss and making heating/cooling systems more efficient—especially important for homes using heat pumps or onsite renewable energy.

  2. Prioritizes indoor air quality and safety. The bill requires homes using this insulation method to pass a strict air leakage test (less than 2.5 ACH50) and to install balanced or hybrid mechanical ventilation systems, ensuring that increased air tightness does not compromise ventilation or indoor air quality.

  3. Addresses practical construction details. The legislation specifies how and where roof rafters must be insulated if not fully covered by the primary insulation layer, helping builders and inspectors clarify compliance and avoid energy-inefficient gaps.

  4. Supports New York’s climate and job goals. By facilitating the use of modern insulation methods, the bill aids the state’s greenhouse gas reduction targets and aligns with broader efforts to create healthier buildings, lower consumer energy costs, and generate jobs in the clean energy and construction sectors.

The daily · weekday mornings

Albany, before your first meeting.

Every bill that moved yesterday, summarized in a sentence and ranked by impact. The Albany Scorecard follows on Sundays.

Free. Unsubscribe in one click. Want alerts on specific bills? Create an account.

Headline styles

Allow Sealed Insulated Attics

Plain English, a few words. Used as the page title.

Sponsors

Primary sponsor
James Skoufis

Senator · Senate District 42

Chair, Investigations And Government Operations

No co-sponsors yet.

History

  1. Referred to rules

Full text

2 pagesUnderlined is new[Struck] is removedOfficial text on nysenate.gov ↗

STATE OF NEW YORK

9921

IN SENATE

October 2, 2024

Introduced by Sen. SKOUFIS -- read twice and ordered printed, and when printed to be committed to the Committee on Rules

AN ACT to amend the executive law, in relation to permitting unvented attics and unvented enclosed rafter assemblies to be sealed with airimpermeable insulation in order to help attain building decarbonization goals

The People of the State of New York, represented in Senate and Assembly, do enact as follows:

Section 1. Legislative findings and intent. The legislature hereby finds and declares it necessary to amend the state fire and building code to better align with the Climate Leadership and Community Protection Act.

New York's six million buildings are responsible for around one-third of statewide greenhouse gas emissions. Advancing building energy efficiency and electrification is a cornerstone of the state's efforts to achieve carbon neutrality and meet emissions reduction goals.

Modernizing and decarbonizing New York's buildings will also create healthier living and working environments, reduce consumer energy costs, and add thousands of local clean energy and energy efficiency jobs.

As New York state transitions into all-electric building construction, a well-insulated and sealed home is integral for the maximum efficiency of a heat pump and onsite renewables. Buildings with HVAC equipment and ducts located in a vented attic have excessive energy consumption because of the inhospitable environment in which they are located.

Unvented attics and unvented enclosed rafter assemblies sealed with air-impermeable insulation provides additional benefits as heat pumps and onsite renewables work best in spaces that don't waste energy due to low insulation levels or airflow leaks. The use of air-impermeable insulation in this manner aids the state's efforts and targets on building decarbonization and energy efficiency.

Accordingly, the legislature finds it necessary to update the building and energy codes to permit the use of spray polyurethane foam insulation in the construction of unvented attics as an additional option to meet code requirements.

EXPLANATION--Matter in italics (underscored) is new; matter in brackets

[ ] is old law to be omitted.

LBD16232-01-4

§ 2. Section 378 of the executive law is amended by adding a new subdivision 21 to read as follows:

21. Unvented attics and unvented enclosed rafter assemblies. To support the goal of reducing greenhouse gas emissions and help achieve the state's clean energy and climate agenda, including but not limited to greenhouse gas reduction requirements set forth within chapter one hundred six of the laws of two thousand nineteen, also known as the New York state climate leadership and community protection act, unvented attic and unvented enclosed rafter assemblies insulated and air sealed with air-impermeable insulation with R-30, maximum U-Factor of 0.038, insulation shall be deemed to meet the requirements of section R402 of the energy conservation construction code of New York state, provided:

1. The house shall attain a blower door test result less than two and one-half ACH50.

2. The house shall require a positive, balanced or hybrid whole house mechanical ventilation system that does not rely solely on a negative pressure strategy.

3. Where insulation is installed below the roof deck and the exposed portion of roof rafters are not already covered by the R-30 depth of the air-impermeable insulation, the exposed portion of the roof rafters shall be insulated by minimum R-3 unless directly covered by drywall/finished ceiling. Roof rafters are not required to be covered by minimum R-3 if a continuous insulation is installed above the roof deck.

4. Indoor heating, cooling, and ventilation equipment, including ductwork, shall be inside the building thermal envelope.

§ 3. This act shall take effect on the one hundred eightieth day after it shall have become a law. Effective immediately, the state fire prevention and building code council shall promulgate the standards required by this act.

Reflowed for reading: line numbers and page breaks removed. Cite the official text.

Sponsor's memo

Title of bill

An act to amend the executive law, in relation to permitting unvented attics and unvented enclosed rafter assemblies to be sealed with air-im- permeable insulation in order to help attain building decarbonization goals

Purpose or general idea of bill

This bill will provide additional options for home builders to meet code requirements by updating the code to allow for a more appropriate R-va- lue for air-impermeable insulation applied to the roof deck in unvented attics and unvented enclosed rafter assemblies. This code change will decrease the cost of utilizing air-impermeable insulation for home builders and homeowners, making a better product more affordable for New Yorkers. This bill would not dictate a specific method for meeting code requirements, rather, it would provide an additional option to meet building code requirements.

Summary of provisions

Section 1: Provides a legislative intent.

Section 2: Amends § 378 of the Executive Law by adding a new subdivision 21 to prescribe the requirements of unvented attics and unvented rafter assemblies sealed with air-impermeable insulation.

Section 3: Sets the effective date.

Justification

Currently, New York's building code has a one-sized fits all approach to attic insulation. However, recent modeling has shown that the energy performance of an unvented attic, insulated and sealed with air-imperme- able insulation will outperform traditional attics by a factor of about 50%. The Code does not properly consider the efficiencies and advantages of utilizing air-impermeable insulation in unvented attics. As a result, home builders and homeowners are required to use the same R-value for unvented attics utilizing air-impermeable insulation on the roof deck as they would for standard fiberglass attic insulation in attic floors. The current Code requires builders and homeowners to install additional insulation in unvented attics, that is providing little to no payback to builders. This bill corrects this oversight and promotes the building of more efficient attics in New York.

In this respect, the building code does not take into consideration the efficiencies that are achieved by insulating and sealing the attic space where HVAC equipment and ducting exists. By right-sizing the R-value for unvented attics and unvented rafter assemblies sealed with air-impermea- ble insulation - New York can incentivize home builders and homeowners to utilize a superior product without pricing consumers out of the market. This change would not require air-impermeable insulation as the only method by which to insulate an attic, rather it would provide an additional option for home builders and homeowners to consider.

As New York State transitions into all-electric building construction, a well-insulated and sealed home is integral for the maximum efficiency of a heat pump and onsite renewables. Buildings with HVAC equipment and ducts located in a vented attic have excessive energy consumption because of the inhospitable environment in which they are located.

Unvented attics and unvented enclosed rafter assemblies sealed with air-impermeable insulation provide additional benefits as heat pumps and onsite renewables work best in spaces that don't waste energy due to low insulation levels or airflow leaks. The use of air impermeable insu- lation in this manner aids the state's efforts and targets on building decarbonization and energy efficiency.

Prior legislative history

New Bill

Fiscal implications for state and local governments

None.

Effective date

This act shall take effect on the one hundred eightieth day after it shall have become a law. Effective immediately, the state fire prevention and building code council shall promulgate the standards required by this act.

Summaries, headlines and scores are AI-generated from the official bill text. How we score bills. Source: NYS Open Legislation.